HOMER CONCEPT | Diamond Origami Clock - white

Like the hour and minute of the digital clock that placed in the left and right independently. The two hands will present interesting combinations at different time. Using special prescription of dicalcium silicate for creating a relief clock face. The twelve graduation lines that radiate from the two axes independently that interlaces and creates unique effects of light and shadow.

Material: Concrete, Quartz Sand, Plastic, Aluminum, Copper, Iron, EPE
Size: 36 x 25 x 3 ± 0.5 / Packaged 39 x 27 x 6.5 cm
Weight:1.35 ± 0.3 / Packaged 1.78 kg

**2017 Golden Pin Design Award**

**Please read before use**
Black Foam
Please do not remove the black foam on the back.
Please do not disassemble any parts on your own.
The level on the back of the clock can be removed to help you mark the position of the screws on the wall. Please measure the ring hanging position before you use.
Due to the different environments, this product is not attached with screws or nails. Please forgive the inconvenience.
Before hanging up the clock, please make sure that the screws on the wall are firm enough to support the clock for a long time.

How to adjust the time
Please do not directly switch the clock hands to avoid damage.
Please adjust the red knob of the movement on the back of the clock.
It is suggested to synchronize watches on the hour or every 30 minute.
The short hand on the left is the hour hand and the long hand on the right is the minute hand.
Synchronize watches on the hour:
The hour hand points to the hour mark direction and the minute hand points to the 90° positive right angle direction. (right above).
Synchronize watches every 30 minute :
The hour hand points to the 1/2 of two hour marks direction
and the minute hand points to the 90° negative right angle direction. (right below).
Please refer to the following examples.
It will have a few minutes of error when using initially.
Please fine-tune it according to the time after a while.

Batteries
The battery is attached to the back of the clock. Please use the general
carbon zinc batteries rather than the alkaline batteries.
Because the battery power consumption is low which resulting in battery being put for too long.
Please check the battery every month to see whether there are problems such as leakage, swelling, or rust, etc.
If there's any of the above problem, please replace it as soon as possible.

Environment
This product is not waterproof. It is limited to indoor use only.
It can't be used in the bathrooms, kitchens and other places,
where the temperature and humidity change rapidly.
Please do not use it in dusty environments.
Each of the cement clock face color and texture is unique,
and it will change with the time and the environment. It's left by nature and it's also the reason you choose this product.